1992 OLDSMOBILE Silhouette

Poorly designed brake hoses ruptured, causing brakes to fail twice.

Rear brake return springs too weak, causing them to break.

Passengers side front/middle seats safety belt retractors failed.(94v027000) *dsh

While driving, a loud knocking noise was heard coming from the front. steering wheel started shaking uncontrollably. consumer pulled over, but was unable to move the vehicle. consumer had the vehicle towed to the dealer for inspection, and mechanic determined that the motor mounts and steering shaft needed to be replaced. *ak

While driving suddenly vehicle stopped. dealer stated that transmission was defective.*ak

While driving and without prior warning the washer bolt came out the engine and caused the driver to loose control of the steering wheel. please provide any additional information. the dealer is aware of the problem. *nlm

Dealership has no parts and now they are saying they don't deal with oldsmobiles. recall 96v015001. *ak

Passenger side seat back collapsed, when vehicle was hit from the back at 60 mph. tt

Cruise control disengages automatically without operator action. tt

When panic stopping the left front brake hose broke and it caused the vehicle to loss control. the right front brake hose was also cracked. please describe. tt

Front passenger seat belt will not pull out of the housing. tt

On very back row of seat on left side of vehicle shoulder belt is extended out all of the way and will not retract back into position. please provide any additional information/attachments. *ak

When coming to a stop while driving transmission automaticly shifts into neutral. also, transmission oil is overheating to the point that the oil is burning. dealer has been contacted.*ak

When car is traveling at 50 transmsion starts lurching like its searching for a gear. then, when it gets up to 70 mph and it stops.*ak

Engine mounts rusted through which caused a loss of control. *ak

Ongoing problem with heater relay burning out whenever heater is set at high speed. replaced heater relay on five occasions. manufacturer would be contacted. *ak

Both rear seatbelt retractor springs are broken, causing it to stay extended, will not retract back in , causing loss of protection. *ak

The seat belt retractors in the second row seats will not retract the belts to the original position. *ak

Consumer discovered that vehicle was leaking power steering fluid. *ak

Driver's seat disengaged from the seat tracks, causing the seat to become unstable. please give any further details. *ak

Seat belts fail to latch properly. seat belts do not stay latched when brakesa are applied. *ak

Loss of abs braking power due to leaking brake lines. *ak

Failure of the driver's/passenger's and rear shoulder belt retractors, the shoulder belts will not retract. *ak

The return spring for the rear brake shoes is inadequate. on two ocassions the right side spring came loose and was destroyed by the axle shaft rubbing against it. when this happens the rear brakes are lost and only the fron brakes wok, resulting in ther pedal going almost to the floor. the most recent incident happened to the brakes on the left side. the brakes came loose after using the parking brake, with resultant loss of rear brakes and only front brakes working, pedal almost to the floor. this time the spring did not break and the brake parts were reinstalled.

Would like to know if there is any way to know if this vehicle has had all recalls repaired or not thanks for your assistance

The transaxle seal blew out and we are being told replacing it most likely won't help, as it is apt to blow out again. 3 independent recommendations are to replace the transmission. at 80,000 miles either problem is unwarranted. *ak

I contacted the oldsmobile corp. about a possible recall on the seatbelts. i hadn't thought about a possible defect until i was told that the third row seatbelts had been found to be defective. i was told that the other two rows were not. it does not make sense to me that the least used seatbelts could be the only ones that are defective. aren't all of the seatbelts manufactured at the same place? i am married we have five children cummulatively. i need all seven of my seatbelts in order to ensure the safety of my family, as well as conform to the law. the seatbelts cost $150 each. i am afraid more will go bad, and will end up costing me a small fortune. i have found that other seatbelts, not the same as my defective ones, are also not working. if the seatbelts have been malfunctioning since 1992 when the vehicle was new, it seems that it is not a matter of just wear and tear, and age of the vehicle. *ak

While driving, the left rear tire blewout, causing vehicle to lose control, cross the median and roll over, injuries were sustained, no specific tire information was given, ohio traffic crash report. *tt

There is no summary currently available

Apv fires

There is no summary currently available

There is no summary currently available

In april 1997, gm notified odi of a rear engine cradle bolt defect in certain model year (my) 1990-91 u vans and my 1988-91 w cars that could result in separation of the steering intermediate shaft from the steering gear.gm identified the problem as excessive crevice corrosion of the engine cradle retainer after years of exposure in a severe corrosive environment.the recall covered approximately 680,000 vehicles registered in 14 rust belt states; including almost 70,000 my 1990-91 u vans.the recalled vehicles received new rear cradle bolts and retainers. gm changed the material composition of the retainers in the my 1992 u vans to provide improved corrosion resistance.the my 1992 retainers are aluminized steel with a 2.5 mm protective coating of zinc/chromate organic.there have been only five (5) failures identified in the subject vehicles after more than 10 years of exposure.based on the low failure rate and the age of the vehicles, there is no evidence of a safety defect trend in the subject vehicles. this recall query is closed.

There is no summary currently available